Search results

Hi, as alastairstevenson wrote You can use console pinout from Hikvision and it's working (can confirm in 100% based on my expierence with Trendnet cams) Then You will get access to console and will see what happening on camera after FW download. From console You can also download firmware...

Thank You for this information. It will be easier to connect.

Good to know about this boxes how to buy this peace of metal.

Hi, I resolved problem with missing box without Hikvision help. I've contacted with local shop/repair service for camera security and asked them about box for this camera or replacement. I was lucky, becuase they had this box from broken camera (other Hik model, but it fit) and they sold it to...

Hi dimension #1: ~90mm dimension #2: ~141,5mm I've found box in local store and now I waiting for package. If will be fit, then I back. But strange for me is that Hikvision support (on three different e-mails) didn't responded for my question. In past they were responsive and helpful for my...

Thanks for info. I asked few Hikvision dealers and Hikvision support. Support doesn't replied (for EU and for Poland). Most of dealers doesn't know for replacement box. So I still searching box in shops and if will find, then I'll back to You.

Thanks! I hope it will be fit

Hi, I have similar camera without junction box and I also looking for it. I searching in the internet and I think it might be Hikvision box DS-1280ZJ-M, but without upper cover. But I'm not sure about that. Still searching for this box...

Hi, I had this issue on Hikvision NVR and solution for me was reset NVR to deault and configure again from base. Before that I tested different computers, cables, switches, router, browsers, etc. - almost everything. I think You can try this solution, but of course before that make a...

Hi, I want to connect via UART to EZViz C4W camera, but connector is quite different than in Hikvision camera. Does anyone know what type of connector it is?

Hello, have You resolved this problem? I have the same camera model DS-2CD2043G0-I and the same problem: camera doesn't appear in SADP and in console after boot showing this logs: armlib]start_dsp 171:>>>>>>>>>>>>>>>>> Start dsp core timeOut, bootInfo=5 <<<<<<<<<<<<< davinci receive...

I've got from my another Hikvision camera image sensor module and replaced for test in DS-2CD2043G0-I Camera started normally and show working image, so it's confirmed that image sensor is broken. For test I installed "broken" sensor in"donor" camera and I've got the same error like below...

Dear All, I have camera DS-2CD2043G0-I after warranty and last time appeared problem with image from camera. Camera booting very long time and when it's comes online (available via WWW and SADP), then on camera image I getting noises like on screenshots. When I touch camera I feel it's very...

HI, so I will stay on this solution, because it's cheap and simply. Thank You for Your help.

Hello I've got Hikvision DS-2CD2143G0-I camera where POE not working, but when I connected directly 12V power, then camera starting and working. I checked it on two Netgear POE switches, where the rest of my Hik cameras working fine, but this one cannot start. So looks like POE module is...