No motion detection recorded only 24/7
- Thread starter jayv
- Start date
App on the phone DMSS. sorry
Does it have anything to do with the below image?
RTSP over TLS - failed to load
Third Party DNSS - failed to load
Does it have anything to do with the below image?
RTSP over TLS - failed to load
Third Party DNSS - failed to load
Last edited:
bigredfish
Known around here
Likely yes but I’m not enough of a network pro to tell you how to change it
I’m guessing either you don’t have P2P enabled on the NVR or Dahua’s P2P server is offline. You may also get that if you’re connected to your home LAN/wifi when trying to reach the NVR remotely via P2P
I have separate profiles for inside/outside my network (local wifi vs P2P)
I’m guessing either you don’t have P2P enabled on the NVR or Dahua’s P2P server is offline. You may also get that if you’re connected to your home LAN/wifi when trying to reach the NVR remotely via P2P
I have separate profiles for inside/outside my network (local wifi vs P2P)
So, i deleted the device from my phone and tried to re add it via P2P mode and it keeps saying 'failed to bind' i then tried ip/domain and it connected and playback was working again. I then checked P2P was enabled on the NVR which it is. But don't understand why it won't connect on the app for P2P?
bigredfish
Known around here
That's correct and it comes up with a message saying 'failed to bind'
I rebooted the nvr
Update!: It worked i'm back and with playback woohoo!
I rebooted the nvr
Update!: It worked i'm back and with playback woohoo!
Last edited:
As for me, I coudn't set up MD recording on my XVR. Case scenario: analog cameras are connected to the 1st XVR, there is working MD, no problem. Then I add this XVR to the 2nd XVR via Ethernet. And on that 2nd XVR only Genreal recording (24/7) is working. As I see it: MD (or SMD, or IVS) is highly connected to the cameras' ability to do MD or to AI functions of a X/NVR. E. g. on of my models can do IVS on itself, others can't - there's simply no such dropdown.
Good evening! I was wondering if anyone could help me please! One of my Dahua cameras has suddenly gone offline and it says 'Failed to find network host' I tried to remove the camera and when I did it couldn't find it, so I had to manually add it back, pop in my password to connect but still comes up as offline. Any help would be appreciated!! Thank you!!