The NCD800 has turned out to be an excellent camera for where I already have wire in place at the middle of a long wall.
I updated the firmware to Hikvision firmware, and with help from earlier in this thread, got it working with BI.
Recently I added a second NCD800 at a different wall.
I updated the firmware with a now available later version of the Hikvision firmware.
Here is the problem with the second NCD800:
I cannot get the sub stream to work in BI, following the detailed steps earlier in this thread.
Wondering if anybody has run into this problem, and if they were able to figure it out.
One possibility might be to flash to the earlier version of Hikvision firmware, since the sub stream worked with the first NCD800 camera (earlier this year).
Since I have the first NCD800 working on the same BI install, I opened the settings of both cameras side by side for both the first and second cameras (different firmware) and went through screen by screen. It all looks the same though there are minor differences in the interface.
Suggestions?
Postscript:
Finally got around to solving the problem.
Applied/flashed the cam to the earlier version of firmware, and all is working fine.
At first some of the features/settings fields were not showing up, but I suspect I had gotten sloppy with the steps of applying the firmware.
Did it again, and everything was fine.
Note to self: follow steps methodically, getting lazy means having to do it over