whoslooking
IPCT Contributor
If your new cameras are version 5.3.0 Tom' fix won't work by the way.
So it wasn't permanent?If your new cameras are version 5.3.0 Tom' fix won't work by the way.
OK a little learning for you is needed, but a simple 5.2.5 hack is all that is needed for both theses camera's.no the new chines cameras have this version
DS-2CD2032 V5.2.8 build 141231
DS-2CD2732F V5.2.5 build 141201
OK a little learning for you is needed, but a simple 5.2.5 hack is all that is needed for both theses camera's.
If you get no luck from Tom, I will provide you with the help needed to sort these out and into English for you.
With no cost for my time.
OK a little learning for you is needed, but a simple 5.2.5 hack is all that is needed for both theses camera's.
If you get no luck from Tom, I will provide you with the help needed to sort these out and into English for you.
With no cost for my time.
i understand completely but this is just one problem . If the Chinese cameras are not connected thhroug nvr intern poe it has to work with the flasht 5.20 fro CBX but dos not. Was i did now was checking again 3.0.15 version from NVR and uploaded with TFTP again 3.0.15 and this is the resultUnless you have 4 series cameras the upgrade is little use to you, the fw you have on your NVR will not allow both region camera's.
So you would need to mtd hack the camera's to remove the region mis-match.
i understand completely but this is just one problem . If the Chinese cameras are not connected the nvr intern poe hast to work with the flasht 5.20 fro CBX but dos not. Was i did now was checking again 3.0.15 version from NVR and unloaded with TFTP and this is the result
strange TFTP started and after all than NVR boot normally but not getting TFTP success.
between update, the NVR was only connected over my laptop and switch nothing else..
.
now the NVR logs like this i will check your mtd hack today .Unless you have 4 series cameras the upgrade is little use to you, the fw you have on your NVR will not allow both region camera's.
So you would need to mtd hack the camera's to remove the region mis-match.
if i use 3.07 or 3.08 NVR i don't have VCA on it. Without linecrossing the hole system are useless for me through 100 of false alarms dally.You can either do the mtd hack or put 3.07 or 3.08 fw onto your NVR both options will resolve this error.
thanks i am downloaded from this side. needs the camera telnet activated or something else?PuTTY download here: http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html
You should have SSH available to enable on the camera.
ok solved problem to get connected with putty was different description from old cbx email to open telnet at camera not ssh and port 23PuTTY download here: http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html
You should have SSH available to enable on the camera.
should i get in with admin and password or root and password ?PuTTY download here: http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html
You should have SSH available to enable on the camera.
You can either do the mtd hack or put 3.07 or 3.08 fw onto your NVR both options will resolve this error.
i do not understand putty ! After writing this on puttyYou can either do the mtd hack or put 3.07 or 3.08 fw onto your NVR both options will resolve this error.