Yea, I should have let you know I was working there today. I know your out there. I was on Old Willets Path. What I did was pulled the wire from the bullet camera back into the building and replaced it with a new wire, installed a POE switch to the nearest outlet, plugged the original wire from the camera in the switch, plugged the new wire from the camera into the switch, ran an 18/2 and cat 5 from the ptz to where I plugged in the POE, plugged in the PS from the ptz, and plugged the cat 5 from the ptz into the switch. There was a box out behind a desk inside the office and everything got plugged in behind the desk. I also drilled a 1/2" hold in the bottom of the wall mount to the ptz and screwed a compression fitting into it and ran the wire from the gang box to the wall mount. All the connections are done behind the camera. I usually do not like doing that because if a connection goes bad, than you have to pull the camera down. In this case, it just made sense to do it that way. I than siliconed all around the base of the wall mount. I purposely mounted it as close to the corner as possible just for the wide range of view for the customer