nvr

Hi I have Dahua NVR DHI-NVR4108-8P-4KS2 (firmware V4.001.0000005.1) and 8 Dahua cameras connected to POE ports. NVR has an ip 192.168.1.108, cameras are on different subnet 10.1.1.X managed by the NVR. I am trying to control the LED's on my cameras programmatically instead of the cameras own...

I installed 24 Dahua cameras and when I start to insert the cameras one by one. THE CAMERAS HAVE DIFFERENT IP addresses. When I connect two or three cameras, and when I try to turn on one more the network disappears after a while, some cameras turn on for a second and turn off just give me a...

Purchased from Amcrest back in 2020 for a project but didn't get to it. Been in storage throughout the pandemic, finally got some time to clear everything. The bios battery somehow had died, and replaced. Please excuse the crudity of the hot glue as I couldn't fine an exact match of the...

1x GW Security GW7808NP 4K 8MP NVR, built-in 8 POE ports, with 4TB WD purple drive pre-installed (only a few hours powered on, under WD warranty til 05/2024). Unused in original box, all accessories included. $230 $200 shipped. All cameras supports Onvif protocol. 6x GW8172MIC, 8MP large 5.5"...

Hello everyone, Just wanted to say your chats here have saved my day on so many occasions...I've finally decided to join to site hoping to help some other members from the experiences that I've gone through. My CCTV equipment is all from Hikvision. Question: Does anyone know of a 2 Wire...

Hello! I am new to this forum and need some help. I have set up two NVRs in different physical locations to each other but on the same network to allow for old coax cameras to still be used (without needing to run new cables - long story). Now one NVR has 8 coax cameras and 1 IP camera the other...

Recently set up a dahua system at one of my new stores and the download speed from smart pss is dramatically slower then it is for my other store locations. The only real difference between this stores setup and the others is that all cameras are run directly into the NVR not a POE switch. Ive...

I'm a CCTV installer from the Netherlands and experiencing some issues with adding an NVR to DMSS on new Android phones (Android version 13) for the last 4, maybe 5 weeks. The weird thing is that the problem doesn't occur when I add the NVR to DMSS on Iphone. The first guess myself is that it...

I'm shopping for a solution. I'm not sure what the hikvision equivlent is maybe id find better results searching that but has anyone been able to get Ankke NC800 working on reolink nvr. The reolink stuff seems to have really good day quality but i'm looking for a better nightvision solution...

Hi, I've an EZVIZ NVR (CS-X4-108P) which is POE only NVR with 8 channels. I've purchased a kit in 2019 which came with 4 cameras. Everything works well till now. But when I'm trying to connect Dahua camera to this NVR, it's not showing up in the monitor or mobile app. I've tried several...

I sold my house and moved before I was able to install a complete setup purchased from Empire Andy. This is a commercial grade 16 channel NVR (rebranded Dahua). Unfortunately, I can't use this NVR since I'm now renting and unable to install anything. I am selling this NVR for $340 and will...

I sold my house and moved before I was able to install a complete setup purchased from Empire Andy. This is a commercial grade 16 channel NVR (rebranded Dahua). Unfortunately, I can't use this NVR since I'm now renting and unable to install anything. I am selling this NVR for $340 and will...

There is a website www.getscw.com. Their cameras are expensive. One of them is listed at $1,400. Does anybody know why are they expensive? Anybody has bought from them?

I lost the changed password for my Hikvision DS-7108NI-Q1/8P at least a year ago and just put it on a shelf. I'd like to reset the NVR to Factory but there's no reset button. I opened it up and I see a memory battery, and more than one set of unused connection pads e.g. jp4, etc. Does anyone...

Model #- DS-7108NI-Q1/M Version- 4.71.007 Build- 220705 I was facing issues with hik-connect app. So I reset the NVR to factory defaults and now I my IP cameras are not visible on my display. They're visible in the online device list but as soon as I add them the green ticks turn to red giving...

I want to add a few new cameras to my Hikvision NVR, but the wiring is problematic in a couple of cases. But if I go through the Attic I could run the Cat6 to my upstairs POE switch. I know I will use up a camera slot(s) on the NVR, but any other downsides, like bandwidth. I'm running a...

Any experience in the forum regarding the new Dahua NVRs, such as NVR5416-EI? https://www.dahuasecurity.com/products/All-Products/Network-Recorders/WizSense-Series/NVR-5-EI-Series/4HDD/NVR5416-EI Is it worth extra money comparing to NVR4416-4KS2/I series?

Hello, DAHUA NVR5864-4KS2 64 Channel devices, one of the existing devices gives the error 0x01(0c6f) with flag restart 1-2 times a day. What are the reasons for this?

Hi, Recently I've bought a DS-7604NXI-K1/4P NVR from a authorized Hikvision reseller in the Netherlands. After setting up the smart events I've noticed some inconsistencies when events we're triggered. After trying to finetune some settings in the configuration I was still unhappy about the...

Hello, I have a problem when I want to connect the dahua full color cameras to the NVR nvr-5432-16p, the nvr recognizes the connection, allows the device to be loaded but does not give IMAGE/VIDEO, we tried assigning an ip within the network range and still not It gives an image, then we try...

Buenas , tengo un problema al querer conectar las camara dahua full color al NVR nvr-5432-16p la nvr reconoce la conexion permite cargar el dispositivo pero no da IMAGEN/VIDEO , probamos asignando una ip dentro del rango de la red y aun asi no da imagen, luego probamos con configuracion de...

Hello all. I have a Dahua NVR 4116-8P-4KS2/L with 3 PoE cameras for a month now. Everything works fine and it is also successfully connected to the internet. But I can not access the web interface. When I try to access it with the IP of the NVR, I can't get to the interface. The connection...

Hello to everyone. I trying to find solution for one no simple task. Need to do Snapshots of 40 cameras from 1 february until now for every1 hour from archive. Its should be like this: camera one - 1 feb 00.00 - 1 snapshot, camera on - 1 feb 01.00 snapshot, camera one - 1 feb 02.00 - 1...

Hi, My friend has NVR5216-16P-4KS2E , all the cameras are connected and IDMSS IOS app has notifications enabled but he gets no notifications. How does one enable push notifications on mobile iOS app for any movements? I feel he is missing something very basic.

I'm planning to buy 16ch hikvision DS-7616NI-K2 NVR but got confused by this " Up to 2-ch@8 MP or 4-ch@4 MP or 8-ch@1080p decoding capacity ". It have 160 Mbps incoming bandwidth. Can it record 16 (Sixteen) IP cameras @ 4 M.P each in full resolution to HDD @ H.265 HEVC compression.

Hey guys, So Noobie here, and with full disclosure, I bought a bunch of stuff and hooked it up figuring I'd learn as I go. Best practice for a guy like me lol. So I bought an NVR5216-16P-4Ks2E, and a fun combination of @EMPIRETECANDY cameras along with a couple of Amcrest amazon 4K on sale...

Hey, This is my first post. I was using zone minder for years but recently gave up on it as it was just too awkward to use and maintain. I purchased a Dahua NVR NVR4108-8P-4KS2/L as all my cameras are Dahua. After connecting them up and going about setting them up things like trip wires I...

What I would like to do is have camera's around my farm. Prefer the one's that Pan/Tilt with night vision. I know that there are two kinds out there, POE and non-POE and I'm thinking about the POE, so that I don't have to run 1 wire for audio and 1 wire for video. I've always had a DVR, but...

Hello everyone, I want to collect all logs (all type logs) of the cameras to my SIEM system. In detail, I want to forward those log to a linux machine by a UDP port. I have open that port on the linux machine (log server). NVR and the linux machine can ping each other. But when I click test...

I am trying to update the firmware on my Hikvison G2 Camera. I have successfully updated 3/4 which were the C models. However one wasn’t the C model and when i open up the virtual host. It gives me a blank white page: Access Error: 404 -- Not Found Can't locate document: /doc/page/login.asp...