ermac
Getting the hang of it
I don't have a ROI setup on this cam, but I can try that too.
Strange noise / pixelation at bottom of camera image
ermac
Getting the hang of it
Yes, I am in Johannesburg
With all my Dahuas, ROI sits in the same menu as the stream bitrates, just on a different tab. I don't know if it improves the image quality of the selected region but it sure degrades the rest.
Reading through your responses and looking at your clip, if this is an artifact, I don't see the origin. You say you can zoom in and out and it stays. I would personally be surprised if throwing bandwidth at this will change the game, but it is relatively easy to try from below.
Reading through your responses and looking at your clip, if this is an artifact, I don't see the origin. You say you can zoom in and out and it stays. I would personally be surprised if throwing bandwidth at this will change the game, but it is relatively easy to try from below.
Last edited:
ermac
Getting the hang of it
So looks like changing from 265h at max bit rate the cam can handle (5632kbs) to 264h at max bit rate the cam can handle (8192kbs) has solved this. Strange... 265h is meant to be better both for streaming and recording compared to 264h.
Also what's strange, this camera's encoding has always been set to 265h but this phenomenon has only recently started to show up.
Also what's strange, this camera's encoding has always been set to 265h but this phenomenon has only recently started to show up.
bigredfish
Known around here
h.265 at least as implemented by Dahua thus far seems to have no useful benefit and creates more problems than its worth
Scruffers
n3wb
Domes edge? like your module tilt stop trigger normally stops at 0 degrees
ermac
Getting the hang of it
Its not a dome, its a PTZ: DH-SD49225T-HN...
ermac
Getting the hang of it
Thanks, noted regarding h.265 thus far on Dahua equip