Hi All,
I recently upgraded the firmwares for my cameras and NVR to the latest and all went well until I went to do a hard reset on the camera. The 4 Phillips screws on the back cover are covered in blue Loctite and hard to remove.
I had one screw that the head didn’t even resemble a philips screw anymore do to it already being buggered up. I managed to remove it but fear tightening it back up due to not being able to get it out again with the stripped out head.
Any info on the size of these screws and where to find a replacement? I am sure Andy would take care of me but don’t want to go down that road for a minor issue.
Thanks again.
I recently upgraded the firmwares for my cameras and NVR to the latest and all went well until I went to do a hard reset on the camera. The 4 Phillips screws on the back cover are covered in blue Loctite and hard to remove.
I had one screw that the head didn’t even resemble a philips screw anymore do to it already being buggered up. I managed to remove it but fear tightening it back up due to not being able to get it out again with the stripped out head.
Any info on the size of these screws and where to find a replacement? I am sure Andy would take care of me but don’t want to go down that road for a minor issue.
Thanks again.