Hi,
Based on recommendation from this board, I purchased the following:
1 Dahua NVR5416-4KS2 NVR
1 Dahua HDW5231R-Z camera
2 Cat 6a Ethernet Cables and this
POE Switch
https://www.amazon.com/gp/product/B00F6DL2FS/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
I’m trying to set up the system (without using the internet) just to check out the camera operation.
I’m a novice at this, so not sure I am configuring it correctly.
I used one CAT6a Ethernet Cable to connect the camera to slot 1 on the POE switch.
I then used the second Ethernet Cable to connect from slot 2 on the POE switch to the NVR.
The NVR is connected to my monitor with an HDMI cord
The default network configuration is using:
MTU 1500
Network Mode: Multi-address
Default card: Ethernet1
IPC Address 192.168.1.108
Subnet Mask 255.255.255.0
Preferred DSN 8.8.8.8
Alternate DNS 8.8.8.8
When I do a Device Search to add the camera, nothing is found.
I’m not sure if I have everything connected correctly or if I need to do a manual add for the camera.
I tried a manual add, but it still is not working correctly.
Any help you can provide will be greatly appreciated.
Thanks
Based on recommendation from this board, I purchased the following:
1 Dahua NVR5416-4KS2 NVR
1 Dahua HDW5231R-Z camera
2 Cat 6a Ethernet Cables and this
POE Switch
https://www.amazon.com/gp/product/B00F6DL2FS/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
I’m trying to set up the system (without using the internet) just to check out the camera operation.
I’m a novice at this, so not sure I am configuring it correctly.
I used one CAT6a Ethernet Cable to connect the camera to slot 1 on the POE switch.
I then used the second Ethernet Cable to connect from slot 2 on the POE switch to the NVR.
The NVR is connected to my monitor with an HDMI cord
The default network configuration is using:
MTU 1500
Network Mode: Multi-address
Default card: Ethernet1
IPC Address 192.168.1.108
Subnet Mask 255.255.255.0
Preferred DSN 8.8.8.8
Alternate DNS 8.8.8.8
When I do a Device Search to add the camera, nothing is found.
I’m not sure if I have everything connected correctly or if I need to do a manual add for the camera.
I tried a manual add, but it still is not working correctly.
Any help you can provide will be greatly appreciated.
Thanks
As an Amazon Associate IPCamTalk earns from qualifying purchases.