Hello,
I've tried to upgrade the firmware on a brandless ip camera.
However the firmware upgrade went wrong and the camera won't boot anymore.
As i couldn't see any network activity coming from the camera i've opened it up and connected it using the serial interface.
The bootloader still works however i get a LZMA data is corrupt error. (see below)
On the camera module it says H200NT-S-E36 which after a bit of googling came up with Hi3518EV200+ module.
I can get data from a tftp server to the camera, however i can't seem to find the correct firmware. Could you guys maybe point me in the right direction?
System startup
decompress.....ok!
System startup
U-Boot 2010.06-svn (Oct 21 2016 - 11:21:29)
Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc2 0x20 0x17
Block:64KB Chip:8MB Name:"MX25L6406E"
SPI Nor total size: 8MB
In: serial
Out: serial
Err: serial
Press Ctrl+C to stop autoboot
CFG_BOOT_ADDR:0x58050000
8192 KiB hi_fmc at 0:0 is now current device
### boot LOAD ERROR<ffffffff> !
## Booting kernel from Legacy Image at 82000000 ...
Image Name: linux
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1890656 Bytes = 1.8 MiB
Load Address: 80008000
Entry Point: 80008000
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux...
LZMA data is corrupt
-- System halted
I've tried to upgrade the firmware on a brandless ip camera.
However the firmware upgrade went wrong and the camera won't boot anymore.
As i couldn't see any network activity coming from the camera i've opened it up and connected it using the serial interface.
The bootloader still works however i get a LZMA data is corrupt error. (see below)
On the camera module it says H200NT-S-E36 which after a bit of googling came up with Hi3518EV200+ module.
I can get data from a tftp server to the camera, however i can't seem to find the correct firmware. Could you guys maybe point me in the right direction?
System startup
decompress.....ok!
System startup
U-Boot 2010.06-svn (Oct 21 2016 - 11:21:29)
Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc2 0x20 0x17
Block:64KB Chip:8MB Name:"MX25L6406E"
SPI Nor total size: 8MB
In: serial
Out: serial
Err: serial
Press Ctrl+C to stop autoboot
CFG_BOOT_ADDR:0x58050000
8192 KiB hi_fmc at 0:0 is now current device
### boot LOAD ERROR<ffffffff> !
## Booting kernel from Legacy Image at 82000000 ...
Image Name: linux
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1890656 Bytes = 1.8 MiB
Load Address: 80008000
Entry Point: 80008000
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux...
LZMA data is corrupt
-- System halted
