DS-7608N-E2/8P with new cameras and long passwords

BigCaddy

BigCaddy

n3wb
Nov 8, 2016
15
2
I'm setting up an older DS-7608N-E2/8P. When I get to the password screen it only allows numbers. All new cameras require a letter and numbers. Is there a setting or firmware that will allow the letters and numbers?

Thank you.
 
BigCaddy said:
I'm setting up an older DS-7608N-E2/8P. When I get to the password screen it only allows numbers. All new cameras require a letter and numbers. Is there a setting or firmware that will allow the letters and numbers?
Click to expand...

Working from the NVR with monitor+mouse? Even on older firmwares you could use letters. Post a picture where you get stuck.
 
  • Like
Reactions: BigCaddy
I'm sorry, I'll try to clarify.
I've set the Gui web password on the NVR fine.
I can access the cameras normally from the gui of the NVR
I can access the cameras from the web via ip address with the longer required password.
SADP allows for longer passwords.

If I go to the NVR and "add IP Camera" and choose "manual" to have an IP on the LAN I am required to enter a password. It doesn't allow for letters or special characters.

DS-7608N-E2/8P
V3.0.10 Build 141126
V5 Build 140816



Attached picture.
22821610068_57f253412f_z.jpg
 
That is pretty old firmware.
On the newer firmware, eg 3.4.90, the button to switch modes between numeric and alpha and special characters is on the on-screen keyboard itself.
What does the '123' button at the right of the password field do?

I presume you know that you can also plug a USB keyboard in?
 
  • Like
Reactions: BigCaddy
Click on the yellow box at the end of the password field, the one with the "123" in it. The keyboard will change to allow letters, numbers & special symbols.
 
Last edited:
  • Like
Reactions: BigCaddy
One word of caution: Long passwords on older systems (firmware) may not work nicely. I think the limit is 8 characters. In otherwords, the system may allow you to create a password longer than 8 characters, but won't accept it when you try to add cameras or login. I had this happen on an old SWANN NVR8-7300. Check your users manual to confirm.
 
that seems to be what is happening. I add the camera to the NVR at the screen above but it never connects.
The NVR has the yellow triangle (Unknown Error)
The Gui on the NVR states (Offline Parameter Error)
 
Were is a good place to start to find firmware that will work with the 7608N? I am able to find it for the NI but I'm afraid I'll mess it up.
 
You must log in or register to reply here.
Top Bottom