DH-IPC-HDW2231R-ZS dead?

W

WannaTheater

Young grasshopper
Aug 18, 2018
48
19
Florida
Camera is no longer feeding Blue Iris... physically the IR lights are no longer on. The corresponding POE port on switch is not lit... and doesn't light when I plug a working device into it. And plugging the dead camera into any other ports doesn't change anything.
So is seems like the camera is dead, and also took out the corresponding switch port. Before I trash this, is there anything else I should try?
 
Last edited:
As a follow up, can anyone recommend an adequate similar replacement? Or even an upgrade recommendation? This is for the front of the house (driveway coverage)
 
Last edited:
Since you're in a state known as the lightning capital of the U.S., it is highly likely the cam and the POE port were fried by ESD from a nearby lightning strike.

But you've also got rain and humidity, so before you decide to order a new cam, I'd inspect the connection where the CAT cable's RJ-45 plugs into the cam's pigtail: check for corrosion and discoloration. That will have to be resolved in any event.

If it is badly corroded, you may be able to clean it up or replace one or more connectors and get the cam working again.

I suggest your next step would be to get up on that ladder and inspect that connection.
 
  • Like
Reactions: JDreaming, bigredfish, looney2ns and 1 other person
As an Amazon Associate IPCamTalk earns from qualifying purchases.
  • Like
Reactions: JDreaming, bigredfish and looney2ns
Most likely something is shorted out. It can be a surface mount capacitor inside the camera as well. I would take it apart and get a multimeter and check for continuity on those capacitors. If it beeps it is shorted. If multiple are shorted, then that is a bit harder to find the one that is actually shorted. I use a Flir thermal camera to "see" the one that heats up the most.
 
  • Like
Reactions: JDreaming
TonyR said:
Since you're in a state known as the lightning capital of the U.S., it is highly likely the cam and the POE port were fried by ESD from a nearby lightning strike.

But you've also got rain and humidity, so before you decide to order a new cam, I'd inspect the connection where the CAT cable's RJ-45 plugs into the cam's pigtail: check for corrosion and discoloration. That will have to be resolved in any event.

If it is badly corroded, you may be able to clean it up or replace one or more connectors and get the cam working again.

I suggest your next step would be to get up on that ladder and inspect that connection.
Click to expand...
^^^^^^This.
 
  • Like
Reactions: JDreaming, TonyR and bigredfish
Thanks all. Removed camera, and I can see a little discoloration on the Cat5 on two of the pins which looks like an arc... most likely internal short. Everything else very clean (this camera is on a patio, but under a patio ceiling- very well protected. No direct exposure to rain, etc.

CAT5 rings out fine with my cable tester.

Will probably purchase two upgraded cameras for the front of the house, and relocate one to replace this cooked one.
 
  • Like
Reactions: JDreaming
TonyR said:
From Empire Tech (@EMPIRETECANDY ) ==>> Loryta 2MP Starlight WDR IR Turret IP Wired POE Camera,Support IVS Motorized Vari-Focal 2.7mm–13.5mm Lens,Smart H.264+/H.265+,IP67 Weatherproof
Click to expand...
Thank you. This looks to be a great replacement. Is there an upgraded version with Vari-focal?
I am thinking this?

Also, for anyone that has used both, is the extra cost worth the upgrade?
 
Last edited:
As an Amazon Associate IPCamTalk earns from qualifying purchases.
  • Like
Reactions: JDreaming
As an Amazon Associate IPCamTalk earns from qualifying purchases.
  • Like
Reactions: WannaTheater and JDreaming
I have both and the 5442 is definitely better, especially at night.
 
  • Like
Reactions: JDreaming, Mike A., bigredfish and 1 other person
WannaTheater said:
Thanks all. Removed camera, and I can see a little discoloration on the Cat5 on two of the pins which looks like an arc... most likely internal short. Everything else very clean (this camera is on a patio, but under a patio ceiling- very well protected. No direct exposure to rain, etc.

CAT5 rings out fine with my cable tester.

Will probably purchase two upgraded cameras for the front of the house, and relocate one to replace this cooked one.
Click to expand...
Keep in mind, even tho you state "its well protected" does not keep moisture from getting into the RJ45 and causing things to corrode, All it takes is a change in outdoor temp to cause condensation in the connection. This is why it is important to properly water proof the connection at time of install. WaterProofing Connections
 
  • Like
Reactions: JDreaming, WannaTheater, bigredfish and 1 other person
You must log in or register to reply here.
Top Bottom