Dahua NVR608-64-4KS2 won't boot.

[arkotech]

Hello, I bought NVR608-64-4KS2 but it won't boot. The drives and the fans all spin, but no activity in the network port and no signal. They think it's the motherboard. Has anybody seen this type of NVR? Maybe it's a connector missing. Thank you for any ideas.

Sent from my Pixel 3a XL using Tapatalk

 

[c hris527]

I see all 8 SATA ports are occupied, Did you try to fire it up with the drives disconnected? Is this new out of the box or was it running before?

 

[EMPIRETECANDY]

Check the fans if can work or not, and use configtool to search the NVR's IP address. If can't find the IP the board dead, ask your supplier to replace it.

 

[pozzello]

that unit also has serial port on the back, worth a try...

 

[arkotech]

that unit also has serial port on the back, worth a try...

Thank you, is there any software to try with the serial port?

Sent from my Pixel 3a XL using Tapatalk

 

[arkotech]

Check the fans if can work or not, and use configtool to search the NVR's IP address. If can't find the IP the board dead, ask your supplier to replace it.

The fans work. Not detected in config tool and no network activity. There is a female connector near the battery that is not corrected. Thought maybe is a missing cable before switching boards.

Sent from my Pixel 3a XL using Tapatalk

 

[arkotech]

I see all 8 SATA ports are occupied, Did you try to fire it up with the drives disconnected? Is this new out of the box or was it running before?

It was new out of the box

Sent from my Pixel 3a XL using Tapatalk