Configuring IVMS-4500 to remote view Husian clone camera

T

thorholt

Young grasshopper
May 18, 2015
56
3
I am having trouble getting it set up for remote view, I have opened up ports in my router as follows:
HTTP 80
RSTP 554
HTTPS 443
and they are set the same in the camera, But no connection, My Dahua cam's all us port 37777 for the phone app, what is the correct settings?
 
IVMS-4500 uses only port 8000 which you'll need to forward, it's not visible in the web gui, but with sdap you can see it. I haven't tried it yet, but you can also change that port with sdap tool.
 
I added the 8000 to my router and I can log into cam locally, when I am on the same router as the camera with the phone, but not remotely from a different ip with the phone, What am I missing?
 
can you access the camera from the browser such as <yourwanip : port>?
 
Yes I have to use firefox but I can run it fine, I set it's internal ip at 192.168.1.99
 
Are these settings correct?
 

Attachments

  • netgear.PNG
    netgear.PNG
    210.1 KB · Views: 27
  • camsettings.PNG
    camsettings.PNG
    132.8 KB · Views: 16
My camera needed both 8000 and 554. On the ivms-4500, you would put port 8000 and your external ip.
 
thorholt said:
Are these settings correct?
Click to expand...

Looks fine and should work, but in this configuration you can only port forward single cam. I usually have different port for each cam. I will test this out in my end and let you know.
 
I should have had my phone setting included, here they are
 

Attachments

  • phone.PNG
    phone.PNG
    50.4 KB · Views: 19
Ok so port 8000 is forwarded OK. Under safety on the cam, rtsp authentication tab, is it on disabled?

Sent from my LG-D852 using Tapatalk
 
Might need to enable it.
 
Enabling it didn't work, I scanned my ports 8000, 554,443,80 with canyouseeme.org and all of them were reported as timed out, Is that a valid test?
 
thorholt said:
Enabling it didn't work, I scanned my ports 8000, 554,443,80 with canyouseeme.org and all of them were reported as timed out, Is that a valid test?
Click to expand...
Yes, then there is something misconfigured, it should say "Success" when scanning a particular port
 
thorholt said:
Enabling it didn't work, I scanned my ports 8000, 554,443,80 with canyouseeme.org and all of them were reported as timed out, Is that a valid test?
Click to expand...

I also do believe some ISPs do block certain ports for whatever reason, don't know if that may be your case.

When scanning the ports did you set a range that the number you want falls into or did you just go 8000-8000 and etc?
 
It looks like the netgear router has some sort of blocker in it for port scanning, no way to turn it off, The router has worked with a dahua camera a few months back though, but dahua uses different ports.
 
Did your try rebooting router?
 
You must log in or register to reply here.
Top Bottom