Cameras flipping between day/night

Riclyo

Riclyo

Pulling my weight
Dec 29, 2019
104
114
Upstate New York
I've been playing around with setting up day/night profiles in the dahua setting but apparently 2 of my cameras are having an issue.
The issue is just before sundown they flip flop every few seconds between day and night. I've gone in and manually rebooted the cameras and that seemed to work but again today I noticed them doing it once again.
one is a IPC-T2231T-ZS-S2
Other is IPC-B5442E-ZE
Thanks
 
  • Like
Reactions: djernie and Riclyo
sebastiantombs said:
Try this- Dahua day/night switch utility - DahuaSunriseSunset
Click to expand...


I tried that before but since I'm not all that computer savvy I didn't think it worked. I just tried it again and when I was hitting simulate sunset I was expecting the camera to go into IR mode. It wasn't until I actually went into the cameras profile I could see it switching between day/night. Thanks for taking the time to point me in the right direction, skimming through 15 pages of posts can get really frustrating sometimes.
 
  • Like
Reactions: sebastiantombs
Riclyo said:
I tried that before but since I'm not all that computer savvy I didn't think it worked. I just tried it again and when I was hitting simulate sunset I was expecting the camera to go into IR mode. It wasn't until I actually went into the cameras profile I could see it switching between day/night. Thanks for taking the time to point me in the right direction, skimming through 15 pages of posts can get really frustrating sometimes.
Click to expand...
You should be able to adjust your sensitivity. Camera----->Conditions----day night setting, I had one of mine set on middle and it would flop around even in day light when clouds would cut out the sun. I have mine set to auto---> Low.

sen.JPG
 
  • Like
Reactions: djernie and bigredfish
So I was unable to get the profile my IPC-T5241TM-AS (2231 is in different location) to change with the utility.
Also when I go into the camera and try and change the sensitivity those options are greyed out and not able to be changed?

Firmware:
V2.680.0000000.5.R, Build Date: 2019-04-04
 
Maybe do a reboot to factory from the GUI and start over again with the camera configuration. Sounds like something didn't get written properly when the firmware was upgraded. Where'd you get the camera, in other words is it a hacked version or an International version?
 
  • Like
Reactions: c hris527
Riclyo said:
So I was unable to get the profile my IPC-T5241TM-AS (2231 is in different location) to change with the utility.
Also when I go into the camera and try and change the sensitivity those options are greyed out and not able to be changed?

Firmware:
V2.680.0000000.5.R, Build Date: 2019-04-04
Click to expand...
When you are in those settings, at least on mine under the picture is a "Default" button.
 
You must log in or register to reply here.
Top Bottom