Search results

hello I have the same problem after updating the firmware on a ptz when it is connected to nvr no longer works the webgui instead just restore and connect the cam directly to the pc works.

hello andy I would need help about a ptz 6al433xa I updated the firmware found on the site dahua DH_SD-Prometheus_MultiLang_NP_Stream3_V2.812.0000032.2.R.220804 after the reboot I reported the standard settings but when I enter with the web page I have no video streaming. while through nvr or...

these are the files in the folder which one should I use for updating?

I downloaded the new firmware for sd6al433xa heavy 800 mega bytes with the entire two files .bin one update.bin and the other allupdate.bin which one should i use? someone knows

hello everyone yesterday I updated with this latest firmware DH_SD-Eos_MultiLang_PN_Stream3_V2.812.0000009.0.R.211011 the ptz 59430 and I could no longer enter the interface web.la cam starts and I see it on the network but I can not enter I tried all tftp, configtool, uart ssh nothing closes...

ciao a me la stessa cosa è successa solo che si è fermato con il filtro chiuso, quindi immagini normali durante il giorno ma nessun infrarosso di notte

Hello to all. for a couple of days I have the same problem and in my opinion due to the latest firmware update. what do you think?

Yes you can go back to old firmware with tftp without rs232. Watch post where it is explained how to do

Has anyone tried to verify with the integrated upgrade if there are updates? I am at 09/2016 firmware

updating I now reported that they know about bug i and they are about to fix it. I hope this is so because the new firmware works fine except IR. with 2016 firmware the autotrack is non-existent ..

I received the news from my reseller and says these cams do not have to update. but then why publish new firmware for these cams ??? it seems ridiculous to me

Another proof that you can download the video on PC and check if it is slider. If it is fluid it means there is a LAN network problem See also how many mega bytes and video If there are so many in tot seconds, there are probably too many details or too much saturation. .

Also try adjusting contrast and detail They have been increased to have good tracking without losing the target

Decrease Bitrate If you look through the web interface you can notice that while the camera registers or tracks the bit rate it also rises to 15,000 20000. I also noticed about my issue with firmware September

do a screnshot video settings please then try to format sdcard with ipcam

Upgrade with tftp without serial cable for me worked. It's already for a while that I reported the problem today is contacting the dealer to see a video with night ir I have now sent hope to update something because the 2016 firmware runs ir but zero autotrack

Search in Google api amcrest i'm at version 3 i use version 2

I did a reset with tftp and installed firmware 09/2016 and it works fine except autotrack. I sent a mail to dahua to report problems. I had already alerted empiretecandy but replied that I did not buy from him.

with new firmware the autofocus seems to me better, pity for my problem

g thank you my problem has a 2017 firmware problem, with 2016 no problem but now I can not go back. I'll hear the vendor

Sorry but you work smartir or turn off beyond 7x?

I installed this For this reason I asked if it is normal what I find on info

I've tried everything but nothing. how do you upload a video that I wanted to show you how is the problem?

according to you is ptz version correct? ask empiretecandy

I have now installed a new firmware but I see that the IR problem remains over 7x goes off but I find that the image is clearer for now I still have to test

now I try it