Recent content by veko

Hello. I have set up smart event based on intrusion detection that I have drawn and that seems fine. Issue I have now is that I get push notification each time someone enters this area. And there are many small recordings. I would like to set that when motion in that area it starts recording 15...

I think its my incompetence with Hikvision. It seems that all evens are recorded as they should, its just that under playback it shows eveything also the false triggers. Looking at notifications from the Hik Connect app it only shows human/vehicle as it should. the yellow box in my original...

Yes I have on that as well, not sure what's the difference is?

When I draw the detection area its yellow as on image, never seen it red before. I only see red when there is a human or a car in view. the tree in the image is yellow. do you mean this setting? I am color blind so its hard to tell if this show event or continuous...

Ok, I think I found it. They all show "Alarm - Intrusion Detection..." I have looked at several over the whole day they all say Intrusion. So I dont get why I get this. However, under playback I see a lot of false triggers. But then I look at the NVR itself and the check the file management or...

Basic Event is not enabled on this. Where can I see this log you talk about? it seem that when I look at the NVR directly and search it finds just human & vehicles. But when going on the web interface, I am unable to search for the same? is there a software I can use on PC, iPad or Phone to...

I am new to this, and trying to learn but there doesnt seem to be much information regarding the settings. The manuals are not very good. First the NVR is a DS-7608NXI-I2 / 8P/S I have set up an area for intrusion with smart analysis But when I look at playback there seems to be false...

Damn this is stupid. I set static IP and now I got image from the NVR. though I cannot see any image from the web interface.

Ok thats new. Does it mean that i need to set a static IP for the camera before I plug it into the NVR?

I have 4x of these cameras. the 10.0.2.61 is a DHCP address set by my network and is outside the NVR. The 192.168.254.x is the address that the NVR DHCP gives the cameras when connected. They all have same setup and password now for testing. In the end I want all 4 cameras to be connected...

Ok thats somewhat good. But not sure why it wont integrate with the NVR then. Is there a way to try with RTSP stream instead, using a custom profile? Do i under this place need to create users etc? Some settings. Modify Settings

Thanks. Never used that before. I have several cameras so I looked at one that is not wired to the NVR but its all the same. Here is some information on the camera. I can't seem to see any port here? Here is some nettwork settings, looks like port 80? Also here is some settings inside the...

I am struggling with the integration of some Pakedge/Lilin CK-CAM-TU652 cameras with the Hikvison NVR DS-7608NXI-I2 / 8P/S. I try to add with ONVIF but nothing happens. All I get is "Offline(Network Abnormal)" I have enabled ONVIF under Network -> Advanced Settings -> Integration Protocol. Im...