Recent content by kmccb

Likely.. I tried two older firmwares and it just says "Firmware unsupported.."

They actually do.. We have the same exact camera in BI.. However, we ordered a few more from the same vendor and they came with updated firmware that removes the "Standalone" option in the Gui..

A guy in my department ordered (2) Unifi G4 Dome cameras to pair with a small BlueIris setup.. When I log into the camera via the webUI it has no standalone option and nowhere to see rtsp info etc.. We have no Unifi OS so is this even possible? Thanks

That works for the full screen, thanks again.. However, It's not automatically logging in even though I enter my creds and tick the "Log in automatically" box.. Do I have to do below for auto login? Thanks again...

Thanks a lot for the help everyone! Super appreciate it!

Thanks again for the reply.. Maybe there is some confusion.. I actually have Edge opening in full screen.. What I need is for BI/UI3 to open the camera full screen (without having to click the button shown below bottom right)..

Thank you for the reply.. I've combed the UI settings numerous times and don't see any such option..

Is there anyway to have BI go fullscreen after logging in? I'm setting up a kiosk machine and have it auto logging into windows and then opening edge and going to BI login page, and it also logs in automatically there.. However, then the UI displays and I have to click the fullscreen button.. I...

I hard wire it in after resetting to defaults and it gets an IP from the router which I verify, via the router and then logging in.. #2 did it! Thanks mate!!!

Tried both hard and Wi-Fi. . Pc has been rebooted a bunch of times as well as the camera. Oh well. :(

I can log into the camera fine via webpage.. I've tried with the http://IPADDRESS:88 and with just http://IPADDRESS.. Using the port at the end I get: Without the port I get: Thanks

Still no joy.. Reset to factory again for giggles, assigned different ip for giggles.. No luck..

When I select Foscam C2..

Thanks for the reply. Tried #1, no luck.. Had already tried #2 but tried it again, no luck.. :( Why would just one camera that was working with the same version of BI not work now?

I recently installed a fresh copy of Windows 10 on my BI computer.. Nothing else changed. Since doing that one of my old Foscam cameras won't connect. It's a C1 with the latest firmware. In BI I add it, enter the IP and user / pass and click find/inspect and then click OK. It gives the error...