Recent content by kc8hnz

That looks awesome but I think its probably going to cost a small fortune. No listings on Ali Express yet... Jason

I have a SAS controller card left over from a previous UnRaid build, that's what sparked the idea in the first place. I am using 15x10TB HGST SAS disks in my UnRAID server and thought I would need two cards to run the disk shelf, but I was able to use just one card, so the second card is surplus...

As all the new PC hardware finally (kinda) becomes available, I'm upgrading my primary daily use PC to an AMD build, so that leaves my old hardware available to use to upgrade my even older BlueIris server. The specs of my existing server are i7 4790 with only 8GB of ram so upgrading to an i7...

I'm looking to pick one of these up from Andy's @EMPIRETECANDY Amazon store this week, what mounting solutions are people using? I like the looks of the corner mounts with a pendant.

Which mount are these going to be using, DH-PFB203W like the older 2231's? Looking to upgrade the few Hik domes I bought and installed before discovering this forum.

I suspect this is a bug with the Note 9s update and not BI's, but I'll throw it out there and see if anyone has any ideas. After a recent phone update, I noticed the alert notification audio sounds have dropped significantly in volume. All settings are turned to max, yet I can barely hear an...

Was it even a San Pedro cactus? If it was I get it, druggies be druggies, but I'm not sure if it even was.

Has anyone seen any cameras that are water tight for extended underwater service that are still resonablly priced? Specifically I'm looking to monitor a drain plug in a large outddor aquarkum that tends to clog with leaves. Any suggestions?

Yup, same here. I was installing new cameras today so was thinking I may have messed up a setting some where but what you all are describing is exactly what I'm seeing.

I disabled uPnP and that did the trick, thanks! How would I tell if it has already been compromised? I have had a robust password on it since the beginning and it seams to be operating normally. Any tell tale indications?

I have a DYN domain for my home IP address and have noticed that the Hikvision web based config is visible to outside IP addresses. Without closing port 80 completely, is there any way to prevent this? Thanks! Jason