Recent content by Joe L Reynolds

I upgraded to v5 today. After install I was able to open 5, everything appeared to be running fine. I could also open v4. I then uninstalled v4 as advised, this is when nothing has worked since. I could no longer open v5, i got it to open once and it told me it was unlicensed and it then...

They are all disabled, i updated this as it hadn't been touched in 14 months... The frame rate setting in blue iris had changed to 60fps, not in the cameras, the cameras still only went to the maximum 12fps if they could (most ran at 0.5) but changing this setting in blue iris back to 12FPS...

Frustratingly i have just spent a good 4-5 hours over a number of visits trying to figure out what the issue was on a clients blue iris server. I have a number of clients running them. I didn't link it to the update until now due to it suddenly running very bad once a raid disk was replaced...

All of my systems currently run on Xeon E3-12 V2 range as they are all in virtual setups and therefore quicksync is unusable anyway. Practically every install is in a HP Gen8 Microserver as this is the perfect size and hardware I have found for the setups I required... 4 drive bays on one...

Hi all I have just shy of 30 blueiris systems out there all running solid and never had any issues with setup, hardware etc I do however need some advice, my largest system to date has been 25ish cameras.... I've goto put 60 into a hotel. What would you recommend hardware wise? Will be a mix...

I nay have missed it, however has anyone asked how to make ui2 the default location once logging in. For example my client goes to his static ip, get the login page, and then get auto logged in and passed to ui2?

Apologies for lack of information, it auto updates so i assume only whatever the previous version to now is. Its running on windows server 2012, which hasn't been updated. BI is running as a service, but always has been and has never been a problem until this latest update... around 70 time...

Has anything changed in the update? Have three Hikvision cameras that have ran without problem for the last 3-4 months I did previously have a problem creating no signal alerts, which I resolved by having the frame rate in blue iris higher than that of the camera, i.e. 20 > 25 However it...

I was hoping to get some advise. I have finished my home office now and was looking to mount a 19 or 21" sceen on the wall with a constant feed of cams, as i have had in the past with a DVR Is there any options for this from blue iris, maybe some way via a pi or similar? Web server stream? My...

Upping the FPS seems to have fixed the motion blue, and the very slight stutter! Thanks a lot both :)

The latest version of Blue Iris... Only just installed and first time user. I'm already running on a 20MB buffer, I reduced iframes thinking it was better but I'll increase them (thinking about it when it was at 50 as default this problem didn't occur) I'll try upping the FPS also Will...

Different clip, but same blurring issue https://www.dropbox.com/s/dq60ljjn5sy8pfl/Cam3.20150823_125422_1.avi?dl=0 Ignore state of drive, not long moved in and house has tonnes of work needed

Thanks Fenderman, hope to make my own contributions going forwards when i get this figured. Does this work and viewable to yourself? http://joereynolds89.dyndns.org:81/clips/Cam3.20150824_121759.avi

I've been trying to play with settings over the last couple of days to try to get what I want from the system, but each change has both positive and negative effects. I believe I am nearly there now, my system has 5*3MP Cams at 2048 x 1536 at 20FPS I'm running on a E3-1240V2 3.4GHz 16Gb Ram...