Recent content by DGMAX99

Just an update! Appears the "92" preset worked!! Not only on the Jennov either, appears it worked on the Vikylin/PanoEagle also. I have not had to reset the home position on either camera in a week. Both still track motion, but then return to the 92 preset position automatically. Before I had...

I'll give that a try! Thanks! I did revisit each camera and look through all the configuration screens via browser and did not find a specific setting for it, hopefully your suggestion will work for both of the cameras I am struggling with!

Took a few minutes to revisit the camera configuration settings directly from the browser and still cannot find a specific setting associated with returning the cameras to a "home" position after motion has been detected and then cleared. I also looked at the configuration screens for a camera...

When I get a minute I will dive back into the config screens and see what I can find. Seems like it would be an obvious setting, but I just don't remember seeing anything associated with it. Thanks!

Two of my newer IP cams (e.g. Jennov and Vikylin/PanoEagle) utilize an app called "VideoLink" for access and control. Both cameras have auto-tracking feature enabled. Problem is, after the cameras track motion to some position, they stay in the position where the movement stop and do not return...

Depending on the type supply voltage available and load, may be able to use a simple SCR, and a momentary switch for the reset.

Late to this discussion but, since your mailbox is metal, and you already have it wired with a switch back to some location, would think it would be easy to just find (or build if you have basic electrical/electronic knowledge) some sort of switch triggered, resettable light box. It could also...

It is actually a different question. See my reply to your post in the "...supply voltage question..." thread you responded to for more details. Yes, it continues to show the camera as "connected" with the actual power being drawn by it. It appears the PoE power may take some level of...

Yes, long time between questions, but no, it is a different question! LOL! I figured out the answer to the question in this thread, but now I'm setting up the same camera on an NVR. Before I was using it as stand alone camera, with PC and/or mobile device access. BTW, the answer to the question...

I also posted this question on the Hikvision forum, but there may be more traffic on this site, so I'm posting it here also. As titled, wondering if there is a way to cycle the PoE power on/off on individual channels? This is on a Hikvision DS-7732NI-I4/24p NVR. I am running a test on a...

I recently purchased a (second hand) Hikvision DS-2CD4526FWD-IZH Dome Camera and need to power it with 12VDC, but only see a "AC24V" connection jack. The manual and spec information for this camera indicates it supports 12VDC power (along with 24VAC and PoE supplies), but is not clear where to...