Recent content by copypaper212

That's exactly the problem. PIR doesn't pick up small movement motion, will try your suggestion. thx

it's seconds! Just edited the OP, i forgot to put hours in front of minutes:seconds:) Just checked, have V5.3.0 build 150513 installed on cameras.

I am using DS-2CD2432F-IW for PIR triggered recording. For some reason the recordings consist of small parts with some parts missing. Example: Person enters camera view, recording is triggered, recorded video is 20 seconds 18:19:52 to 18:20:12, than 40 sec gap, and next short video starts at...

UPDATE: badmannen's suggestion worked. "All events" does record on PIR and when disabling all other alarms/detections on cameras only PIR triggers the recording. Thank you Italian guy;)

no, will try - but won't this make it record from also from regular movement detection? (though it is disabled on camera, so should work) Thank you for suggestion, will try and report back.

Found this tutorial: Using IP camera based PIR sensors with Blueiris Set up cameras the same way. Now PIR triggers the alarm output when motion is detected by this sensor, how to make iVMS-4200 PCNVR record from this alarm output?

bump, any suggestions?

How do i configure iVMS-4200 PCNVR to record on 2432FIW's PIR? There are 3 options in iVMS-4200 PCNVR - record on motion detection, record on alarm, record on alarm and motion. As i understand i should make PIR send alarm output which iVMS-4200 PCNVR will record on? Here is what i did: 1. In...

Hm... It's working on iVMS 4200, but not in browser. Who needs the browser anyway.

Guys, i have 2 DS-2CD2432F-IW. They record to mni SD card. When accessing cameras remotely, there is a problem moving playback back or forward. For example if i want to see record closer to the end, i must see full record first.... You can move the timeline, but it doesn't make the record move -...

Thanks guys! Worked. Reseted. Changed ports to 8003 and 83 and it works. For some reason it didn't like 8001/81 combo.

Yes, i put the :81 at the back. Shows this message -> http://easycaptures.com/fs/uploaded/991/9762565249.png Guess that the only option. Just tried pressing and holding the button at the back- nothing. Don't see it in manual - what are the steps for manual reset?

Guys, With your help i've chosen set-up for basic parking monitoring, thank you for all your advices. Now it am trying to set-up remote access. Since i don't have NVR (the cams write to SD) i've changed the ports of one the camera's. After i did that the camera keep showing and disappearing from...

Bump. Guys help. Camera#1 keep rebooting all the time(showing & disappearing in SADP tool). Can't connect locally nor remotely, can't change ports back to 80/8000 either - says modification failed ID:001 Camera#2 works both locally and remotely. Here are the settings...

Is there a way i can check what ports are in use? I've tried 8001, didn't work - the camera rebooting all the time. Seems like 8001 is used?