Old URL: http://<IP_Address>/onvifsnapshot/media_service/snapshot?channel=1&subtype=0
New URL: http://user:password@<IP_Address>/cgi-bin/snapshot.cgi
Did you try a reset / factory reset?Helloo there,
i have tried to update my camera, but now i have got no picture from it. I can log into it, but there is no video stream.
I have tried to change firmware to pretty much anything i can find with no luck.
My camera is
IPC-HDW2431T-AS-S2
with firmware
V2.800.0000000.24.R, Build Date: 2020-10-14
This is the original firmware my camera was shipped with. I was unable to upgrade or downgrade firmware.
I was only able to brick video output, and cant get it back to work.
Can you guys help me with that?
I have tried config tool, but firmware upload crashes at 50%, upload fw with internet explorer but with no luck.
I have reseted camera many times.
Thanks for help
Hi, yes I have tried resetting and hard resetting it and then tried to upload some firmwares again, but it always gets stuck at 50% and then it only reboots to the same firmware without video streamDid you try a reset / factory reset?
Can you try to update from the NVR if you have one?Hi, yes I have tried resetting and hard resetting it and then tried to upload some firmwares again, but it always gets stuck at 50% and then it only reboots to the same firmware without video stream
i bought it from aliexpress, years ago, with no warrany. I wanted to find some new firmware and found this threadIf you have them for less than 2 years than you still have warranty, assuming you baought from Andy.
Not sure you can flash Andy firmware on such camera, not sure your previous version is compatiblei bought it from aliexpress, years ago, with no warrany. I wanted to find some new firmware and found this thread
Send me a dm, i will check which fw is the best for you.Is there a more current version for the ipc-t2431t-as available? I see the Amcrest version of this camera has a more recent firmware with a build date of 2023-04-08.
Thanks