VLANS over point to point bridge

[Cleve]

I have a PTP bridge set up between my house and pump house. In the pump house is a ubiquiti managed switch. It has two POE cameras and a AP connected to it. I tagged ports 2 and 3 with VLAN 40 which is my camera network. Dash board shows those ports tagged in the Camera network but the cameras are not getting a new IP address within that network. My question is, does the bridge have to be on the same VLAN as the cameras? I have changed camera at the house to the camera network and had no problem. The only difference here is the radio bridge.

 

[TechieTech]

The ports the cameras are on should be configured for untagged VLAN 40 as the cameras certainly don't support VLAN tagging. I can't imagine any circumstance which you would want an end device to be running tagged; only if it's a device that should be on multiple VLANs such as another switch, a firewall, or a wireless access point that supports multiple VLANs.

 

[Cleve]

OK Thanks, I Think I got it figured out/