Is there a way to tie a preset of a pan/tilt camera to a profile so when that profile is active the camera will point at certain location and start recording? Reason is I have two indoor cameras and when I'm at home I have the preset point them at the ceiling. However, I want to have them point to some areas of interest when I am away. Can you tie a preset to a profile?
Edit: I think I found a post that could help me. Should really try searching before asking :shame:
https://www.ipcamtalk.com/showthread.php/9748-Profiles-and-PTZ-Presets?highlight=Profile+camera+preset
However looks like the Auto-cycle won't work if there's only 1 preset active for the profile. To get around that I had to set two presets to point to the same physical area, and use auto-cycle to cycle between the two presets.
Edit: I think I found a post that could help me. Should really try searching before asking :shame:
https://www.ipcamtalk.com/showthread.php/9748-Profiles-and-PTZ-Presets?highlight=Profile+camera+preset
However looks like the Auto-cycle won't work if there's only 1 preset active for the profile. To get around that I had to set two presets to point to the same physical area, and use auto-cycle to cycle between the two presets.
Last edited by a moderator: