I had this camera set up on the bench and it's operating just fine. If I recall correctly I used the config tool to change the IP to the 192.168.0.x subnet I'm using.
Installed to a building with a cable run to the loft space where there is a Netgear GS308P hub providing a POE port. Both LED's are lit. There is a drop cable to the router and again both LED's are lit.
Unable to see the camera using config tool (toolbox) on 192.168.0.x so I changed a laptop IP to 192.168.1.x (fixed IP) and tried again with no success. I think I've missed something here. Am I going to be able to reach the camera via the router with a laptop on a .1 subnet or do I need to connect another cable from the Netgear in order to reach the camera on .1?
Edit:
Netgear LED's are Left=Orange (100M), Right=Green (POE powered)
Installed to a building with a cable run to the loft space where there is a Netgear GS308P hub providing a POE port. Both LED's are lit. There is a drop cable to the router and again both LED's are lit.
Unable to see the camera using config tool (toolbox) on 192.168.0.x so I changed a laptop IP to 192.168.1.x (fixed IP) and tried again with no success. I think I've missed something here. Am I going to be able to reach the camera via the router with a laptop on a .1 subnet or do I need to connect another cable from the Netgear in order to reach the camera on .1?
Edit:
Netgear LED's are Left=Orange (100M), Right=Green (POE powered)