Q-See Closing Doors Jan 31st 2021 No More Remote Viewing, Options to fix

[bhagwan11]

Hi @bhagwan11

I believe these were non-Dahua compared to the typical Dahua OEM prior models Q-see sold.


so perhaps Uniview or ?? don't recall the oem at this time .. I know I looked it up in the past and posted in a thread here ..


View attachment 190790
View attachment 190791

Thank you, any help is greatly appreciated. I did get the original app working. So, I can see the cameras while connected to my network. Thanks again.

Yes it works as I connect via IP address and only in home network. I cant see when I’m outside of the house. Is there any other ways to view remotely? Or I need to replace the whole system? So frustrated.

If you read through the thread, they discuss ways to utilize the current NVR to see your cameras remotely. I am ok with computers but no expert. Some of the things they talk about are above my level, but I'm learning.

 

[camera5690]

In case this helps anyone, the Uniview app EZView is a drop-in replacement for Q-See Presidio which is no longer available. The H16CN1.1-2 NVR is the Uniview NVR302-16E-P16-B-DT as confirmed in the XML configuration export. I haven't tried a firmware upgrade to Uniview because I'm worried that could brick it, but the app works exactly the same, just skip the signup page and go right to adding the NVR.