PTZ Horizontal line setup

[pagu]

Hello everyone,
i installed an ptz, how i can regolate horizon line without touch hardware camera?
the support are not have perfectly horizon level line 0°, and i get a little roller coaster effect on pan,
i see a little bit hight one side and low in another side.
Thank you

 

[looney2ns]

The support must be installed plumb, or you will get the results you see.

 

[guykuo]

^^^^ This ^^^^
Unfortunately, this is only fixable by physically leveling camera mounting.

 

[pagu]

The support must be installed plumb, or you will get the results you see.

thank you looney2ns and guykuo, ok! have you some tool that i can use? i have camera in a bad position to adjust, it's so hight.
first to go adjust the position, which tool i can use? usually in wifi hotspot have bubble level incorporated.
Thank you

 

[IAmATeaf]

You just need a spirit level to it don’t you?

 

[looney2ns]

thank you looney2ns and guykuo, ok! have you some tool that i can use? i have camera in a bad position to adjust, it's so hight.
first to go adjust the position, which tool i can use? usually in wifi hotspot have bubble level incorporated.
Thank you

https://www.amazon.com/WORKPRO-Magnetic-Plumbing-Aluminum-Reinforced/dp/B09ZPB3FC7/ref=sr_1_1?dib=eyJ2IjoiMSJ9.Mzp1WtbjdKPK3MwbYzAvJBWK_oYqbZ_bIndsaT31CK4whk_m2bCZzAlz442BzMjRQnKxir0OzNsjBjOki3hW-X8GBNmVfsrKtH9MdLjwN-3vA2k6gTfAImUFe_PHIetFgcVeqsblsZfdDWULBDE0l30PiH8Y5IEQgUa8IHFCCzJUDyg_b6hvoeab7J_4RPoHil5NDjySsWWmwTZQC_wzBWSiSzgIxl33A_SEt5BSxUin4uWRXFVaduNlGDUYCBdyOZ4WL4HCpXlA1YCmlOn4wV3ryCD1XJr_aARqP5-LVj4.1YTjXJKXtw_HbNlslfOVO17lPFB2Q1KECNRHzcbE0Y4&dib_tag=se&keywords=12%2Binch%2Blevel&qid=1712183468&sr=8-1&th=1

 

[pagu]

yes i understand, i found circle plumbing. I will put it below on ptz support, where are located 3 screws.
It should be fine
thank you

 

[guykuo]

I have never seen a circular level that can be read from BELOW. They all have been read from above and were designed to be placed atop a surface. Below the mounting arm would be upside down placement. I'm surprised you found a circular level that can be used in that orientation.