I have Hikvision PTZ camera.
-PTZ camera only has 2 pin RS-485 input (half-duplex)
-I am using 232Analyzer app to test.
-The converter I use is UT-890A RS-485 to USB.
I am trying to read the location information of the PTZ camera from the computer.
I can control PTZ using RS-485 via pelco-d. It acts on the information I sent.
I am trying to read pan current position information but I am not getting any turn information. Does anyone know the cause of this problem?
Can anyone help with this?
Every opinion given is worthy of respect.
-PTZ camera only has 2 pin RS-485 input (half-duplex)
-I am using 232Analyzer app to test.
-The converter I use is UT-890A RS-485 to USB.
I am trying to read the location information of the PTZ camera from the computer.
I can control PTZ using RS-485 via pelco-d. It acts on the information I sent.
I am trying to read pan current position information but I am not getting any turn information. Does anyone know the cause of this problem?
Can anyone help with this?
Every opinion given is worthy of respect.