Re: Please upgrade Blue Iris to version v4.3.9.5 or above to be compatible with Reoli
I should add this bit of information. I have two different systems running at different locations. At one location I installed two Reolink POE Cameras and they worked fine. These are the fairly cheap 4mp non wireless models. I then added two more for a total of four cameras all of them the same model, POE, non wireless. They work ok with a bit of a picture problem from time to time. The best way to describe the problem is the picture goes into "matrix" mode. With these four cameras, the CPU on that machine is very loaded. It works, but its loaded.
Based on this I decided to buy one of the Wireless versions to add at my other location. That location already has six cameras, five hard wired and one wireless. The trouble I had was with this wireless camera. That one camera really bogged down this system and I could never really get it to work properly on BI. The "matrix" ghosting and freezing was really bad. This was after changing the cameras internal settings way down, 720p, baseline, etc. The cpu on this system is better and it never showed to be over 35% loaded.
Then I read on the net somewhere that Reolink had a firmware upgrade coming up so I waited until this upgrade was out and tried to load it. In the process the camera became inoperable and I could not get it to reset. That is until yesterday, I gave it one more try and its up and running. So far with the camera once again set to the lowest settings, its working and its working better than it did before. I have the latest BI updates and the new firmware in the camera. I'm not sure which one made things better.