Today i have managed to Drop a chinese 7608n-e2 NVR ceilling to the ground ( while the case is closed ) After booting up, everything went normal, but SADP tool can not see the device anymore. TX/RX led on the front panel is blinking ( not so often ) and i also see the led on the router . So the cable is seen. But as the device is set to DHCP, its not getting any ip adres, also cannot ping when setting static one
The cables, which are connecting the mainboard with the front panel, are connected good. and no parts are missing. What could be wrong?
I am sure the router , cable etc are OK. Before the accident the nvr was working good.
The cables, which are connecting the mainboard with the front panel, are connected good. and no parts are missing. What could be wrong?
I am sure the router , cable etc are OK. Before the accident the nvr was working good.