nayr
IPCT Contributor
that would be so much better than the other view, if it was rotated.. just turn your monitor sideways
You didn't get that from the label! Have you tried it? Good stuuff!Luponic Distortion.
i have about half of my cameras in 4x3 rotated 90 degrees in corridor mode.Strange... that corridor pattern is pretty much useless on s500 because it's 4:3
I have a black belt in Google-Fu and unfortunately no I haven't tried it.You didn't get that from the label! Have you tried it? Good stuuff!
you went too far with it, when it actually got dark enough outside there was not enough lighting.. so it turned the gain up to maximum so the image would not be black.YIKES! WTF is going on here? I masked all but two LED on each side of light sensor (total of 4 LED). Looked OK earlier, but now:
View attachment 9878
If you are masking LEDs in the dome, you may have to do it on the inside dome cover, but I haven't tried it myself.YIKES! WTF is going on here? I masked all but two LED on each side of light sensor (total of 4 LED). Looked OK earlier, but now:
View attachment 9878
I covered the LED directly. May remove some of it this eveningIf you are masking LEDs in the dome, you have to do it on the inside dome cover, but I haven't tried it myself.
Sorry I couldn't help more; I'm a novice user. I DID enable motion detect on BOTH camera software and NVR. I am able to "draw" the motion detection area on the NVR and receive alerts.Yes, I know this, but NVR message "this camera does't support motion" and I don't draw area. Also I have Dahua 4116 (HiSilicon3535), and this NVR find Longse 8999 port, work PTZ and work motion detection. Firmware on Hik latest. I think longse wirmware problem and write support.