I received a new IPC-HDW5231R-ZE from Andy (great service), but am stuck as to how to get started. I opened the box, and connected the camera to my Unifi POE switch. The switch shows 10/100 and POE+ drawing 2.76W. The guide says the camera should come initialized to an IP address of 192.169.1.108. No such address connects on my network. I cannot ping it nor connect from IE. I installed the configuration software from the tiny DVD that shipped with the camera. It does not find the camera.
I have one flat network based at 192.168.1.XXX. No subnets or vlans. I use a Unifi USG gateway as the router. The router event log does show a MAC address connecting to the LAN when I plug in the camera. I see a device listed with that MAC address, but it has no IP Address or Type.
I did not install an SD-card. Is that necessary?
What am I doing wrong or am I missing?
Thanks
I have one flat network based at 192.168.1.XXX. No subnets or vlans. I use a Unifi USG gateway as the router. The router event log does show a MAC address connecting to the LAN when I plug in the camera. I see a device listed with that MAC address, but it has no IP Address or Type.
I did not install an SD-card. Is that necessary?
What am I doing wrong or am I missing?
Thanks
Last edited: