Multiple BI servers behind one IP address. How to combine?

K

Kelly Murphy

IPCT+ Member
Dec 13, 2018
19
9
Montana
Hello all, and thank you in advance for any suggestions.
I've been using Blue Iris on different construction sites, and I'm now pretty familiar and happy with it. Generally use 3 or 4 Amcrest IP cameras and record 24-7. (I've found motion alerts to be just too frequent for my purposes).
At each site I configure internet with a public IP address so project managers and owners can log in to view and review.

Now I have a jobsite where I'll have multiple job trailers connected via WIFI bridges. Each of 4 trailers will have a BI server installed, running it's 4 or 5 cameras. This way I'm not constantly filling my radio waves with video traffic. However, each of the 4 servers is behind a single public IP address..

Any suggestions for combining the feeds into a single "Master" server? Or suggestions for establishing routing to each specific server? Just not sure of the best approach here.

Thanks again.

Kelly
 
TonyR said:
Perhaps this will help ==>> Show cam stream from a Remote BI server on a Local BI server
Click to expand...
That looks promising. If I understand, the actual recording still happens at the remote - camera & server location, it just forwards a livestream image.
I'll have 150 mbps synchronous connections between my job trailers, I may have to start looking into traffic levels per camera. Do you happen to know if the cam stream would be the same size of smaller (packet wise) than the normal recording stream?
 
Kelly Murphy said:
That looks promising. If I understand, the actual recording still happens at the remote - camera & server location, it just forwards a livestream image.
Click to expand...
Yes, but the local can also be set to record, alerts, etc. just like the remote.
Kelly Murphy said:
Do you happen to know if the cam stream would be the same size of smaller (packet wise) than the normal recording stream?
Click to expand...
Not sure but I think it is. Also, later versions of BI5 allow substream motion detection / recording and main stream live view.
 
While you could do what @TonyR suggested, it isn't very efficient. It will substantially raise the CPU load on all of your Blue Iris servers and ultimately deliver inferior video quality. I suggest you just connect one "master" BI server to all of the cameras directly if you have the bandwidth to spare, and it sounds like you do.
 
  • Like
Reactions: Mike A. and SouthernYankee
The alternative is that you just need to host each Blue Iris web server on a different public port when you forward the ports in the router, and then anyone who connects needs to open four browser windows to see all the cameras at once.
 
  • Like
Reactions: Mike A.
You must log in or register to reply here.
Top Bottom