Do you have anything to point at in the dark that would require zooming out. For example, a building across the street?Here are a few nite images, first 2 are the same as the day images earlier and then a swing around to catch the front steps. Front steps have added light from front door.
Remember, this is a 4X, the first picture is the driveway at 1X and the second is the mailbox at the end of the drive at 4X. Trees on both sides prevent shooting at a house nearby.Do you have anything to point at in the dark that would require zooming out. For example, a building across the street?
Thanks for sharing!
Oh, interesting, in the past same firmware applied to both camsYes, so far so good. 1000 % better than the original V2 4X.
I had asked Jack about the new firmware and here is his reply.
IPNC_S2l2.0.1_build201607221508 this is 10X update
4X Please do not update.
I did not measure it before installing but it is close to 4" + the weatherproof cable connector adds another 1 1/2. This is why I used it to enter the soffet instead of the short section of pipe from the other camera, see post #389.The night images look very good. But now it has external PoE and my junction box is too small to house it. Do you have the dimension of the PoE splitter? Thanks.
If you're too lazy to read the 2nd page of posts then you shouldn't be buying this.Late to the 400+ thread here, compatible with which NVR recorders like hikvision or Dahua or this one a totally over the local LAN and try to get at it from the NVR from the outside the NVR LAN?
Also to me the main advantage of Huisun/Imporx it uses Hikvision protocols.
Have you tried comparing 10x with 4x? In terms of IR output?Yes, so far so good. 1000 % better than the original V2 4X.
I did not compare before installing but they seem to be about the same. Right now I have the 4 in the front of the house and 2 10's in the rear. No way to do a real comparison but they look close. Each side has the older 3x and they look just as good.Have you tried comparing 10x with 4x? In terms of IR output?
wow, now you have more of them then I do, aren't you afraid of owning so much junk? ))I did not compare before installing but they seem to be about the same. Right now I have the 4 in the front of the house and 2 10's in the rear. No way to do a real comparison but they look close. Each side has the older 3x and they look just as good.
Nope!! I'm done now, everything in up and working so now I need to spend time with BI and tweak it.wow, now you have more of them then I do, aren't you afraid of owning so much junk? ))
is your "v1" with s2l or a5s? You can check with batch tool as I recall they started putting new chipset a while back. If it's s2l then you will likely be able to upgrade using the same v2 firmware.any firmware update for the v1??