Main stream triggers too late after alert

P

poohbear

n3wb
Jul 3, 2022
4
0
Seattle, WA
I have a 4K camera configured for continuous+alert recording and set to to trigger on AI alerts. The pre-record trigger time is set to 12 seconds. Seems to work as expected, but when I view the clips, the first few seconds of the footage is always in low-resolution (substream) before the main high-res stream kicks in.

What can I do to improve this? Obviously it will take the AI a few seconds to fire an alert, but I figured the 12 sec pre-record should be plenty of time to have enough footage from the main stream to prevent this from happening. Am I missing something?
 
Make sure in the camera GUI that your FPS and iframes are the same.

In BI camera status it will show as KEY and that needs to be 1.00. If it is less than 1.00 then these issues can happen, as well as motion being missed or triggering late.

Plus, you should consider continuous+ triggers as that can help in some situations as well.
 
  • Like
Reactions: poohbear
Yep that means that the iframes is double the FPS and that can result in up to a 2 second delay depending on when the trigger happened.
 
  • Like
Reactions: poohbear
poohbear said:
I have a 4K camera configured for continuous+alert recording and set to to trigger on AI alerts. The pre-record trigger time is set to 12 seconds. Seems to work as expected, but when I view the clips, the first few seconds of the footage is always in low-resolution (substream) before the main high-res stream kicks in.

What can I do to improve this? Obviously it will take the AI a few seconds to fire an alert, but I figured the 12 sec pre-record should be plenty of time to have enough footage from the main stream to prevent this from happening. Am I missing something?
Click to expand...
As noted you should be using continuous+trigger. Otherwise you are waiting for an alert to be confirmed by ai and you wont have a high res image in the event of an ai failure or missed detection.
 
Last edited:
  • Like
Reactions: looney2ns and poohbear
fenderman said:
As noted you should be using continuous+trigger. Otherwise you are waiting for an alert to be confirmed by ai and you wont have a high res image in the event of an ai failure or missed detection.
Click to expand...
It should read continuous + trigger. I fixed it.
 
  • Like
Reactions: poohbear
You must log in or register to reply here.
Top Bottom