Lorex lnz44p12
- Thread starter lugnut3
- Start date
mat200
IPCT Contributor
- Jan 17, 2017
- 15,034
- 25,343
What do you mean by not work - like you don't get an image or the PTZ controls don't work?
That is a Dahua OEM, so typing in the IP address, username, password and hitting find/inspect should find the correct protocol.
That is a Dahua OEM, so typing in the IP address, username, password and hitting find/inspect should find the correct protocol.
PTZ does not follow strict ONVIF protocols, so if the default didn't work then you have to try the different ones. For most Dahua OEM like Amcrest and Lorex, New V4 works, but for some it is one of the others labeled Dahua, so try each one and one of them should work. If not, then try the Amcrest and Lorex ones.
I have tried all the ones you listed and nothing workedPTZ does not follow strict ONVIF protocols, so if the default didn't work then you have to try the different ones. For most Dahua OEM like Amcrest and Lorex, New V4 works, but for some it is one of the others labeled Dahua, so try each one and one of them should work. If not, then try the Amcrest and Lorex ones.
AP514
Pulling my weight
I had blueiris set to the wrong camera. I knew it was something I was overlooking. Again thanks for your help!
That will do it - most of us do not use the camera drop down and let the find/inspect find the best protocol for the camera.
The mistake you make and sharing the solution might help other people in the future in case they run into the same problem like you.
