Hey all
A friend who has 5 Hikvision 2332-i cameras hooked up to a Hikvision NVR is having a little issue that i would i would check with all you guys to see if anyone else is experiencing.
All cameras are setup and have been running perfectly except for a rather annoying issue,
Motion detection has been setup on each cam, the detected area has been draw for each cam and sensitivity set to 40 and working fine, periodically could be a day or two or in a few cases within hours the detection area will reset to the whole screen and sensitivity will go from 40 back to 100.
This is happening on all cam
Yes he is saving each time he makes changes
Have any of you experienced this?
A friend who has 5 Hikvision 2332-i cameras hooked up to a Hikvision NVR is having a little issue that i would i would check with all you guys to see if anyone else is experiencing.
All cameras are setup and have been running perfectly except for a rather annoying issue,
Motion detection has been setup on each cam, the detected area has been draw for each cam and sensitivity set to 40 and working fine, periodically could be a day or two or in a few cases within hours the detection area will reset to the whole screen and sensitivity will go from 40 back to 100.
This is happening on all cam
Yes he is saving each time he makes changes
Have any of you experienced this?