how to setup hikvision PIR for xprotect

R

razorseal

Getting the hang of it
Oct 17, 2014
149
6
I have it setup and it works on the blue iris, however I couldn't figure out how to enable it for the xprotect GO.

any ideas?
 
You have to setup a hardware event for that. Then go in the cameras settings in Milestone and use that hardware event and turn of motion detection which is Milestone's motion detection.
 
networkcameracritic said:
You have to setup a hardware event for that. Then go in the cameras settings in Milestone and use that hardware event and turn of motion detection which is Milestone's motion detection.
Click to expand...

I already have the hardware event setup (from Blue Iris)

just not sure where in camera settings it is. I see something similar in even my 2032s for it. so it confused me
 
Huh, so you have an interface between BlueIris and Milestone XProtect that takes the settings from BlueIris and sets up the hardware event on Milestone? Very cool. I had to actually go into Milestone XProtect Manager, click on events, right click hardware events, add the event before I can use it but your way sounds so much easier. Does it also go into the cameras configuration settings in Milestone and set that up too?
 
You must log in or register to reply here.
Top Bottom