Hikvision HTTP MJPEG Stream

[TinuSwiss]

Hi

I want to join my Hikvision Cams to my Home-Automation System RTI.
On my RTI System i have only a Generic MJPEG Video Viewer.


Can u tell me the correct URL for the MJPEG-Stream.

I already try this:


http://user:pass@192.168.10.24/Streaming/channels/102/httppreview
http://user:pass@192.168.10.24/Streaming/channels/102/preview

http://192.168.10.24/Streaming/channels/2/httppreview
http://192.168.10.24/Streaming/channels/102/preview?auth=xxxxxxxxxxxxxxxxx==

I see the Stream for 1Second, after that i see this failure:

<ResponseStatus version="1.0"><requestURL>/Streaming/channels/102/preview</requestURL><statusCode>4</statusCode><statusString>Invalid Operation</statusString></ResponseStatus>

 

[studiodubio]

Hi, I have the same issue with 'Invalid Operation error'. I want to embed the mpeg stream into my homepage. Any help appreciated.

 

[Dreamboat]

First you have to set the sub stream to MJPEG while this is the only one available for MJPEG request (2xx2 IP cam series).
Then use the following syntax:

http://user:pass@ip_address/Streaming/channels/102/httppreview

This works for me (I've tested using VLC player).

 

[technicaldisruption]

Dreamboat. Big thanks. I've been trying to solve this issue for over a year with no luck.

 

[Billkater]

First you have to set the sub stream to MJPEG while this is the only one available for MJPEG request (2xx2 IP cam series).
Then use the following syntax:

http://user:pass@ip_address/Streaming/channels/102/httppreview

This works for me (I've tested using VLC player).

I did this but the video stops after about 5 seconds. I have to refresh the page to start it again. Any clue?

I used "http://admin:password@192.168.1.64:8064/Streaming/channels/102/httppreview" red text without the quotes

 

[nayr]

try using VLC Player as Dreamboat