Even if they are giga, your are probably running in auto and it may be auto-negotiating to the 100mbs of the switch. At first I thought you meant your were using link aggravation was going to suggest you double check your aggregation settings. you might be able to set there speed under the driver/device properties in device manager.
Sounds like his switches were 100Mbps only. You should almost never need to manually set a link speed anymore. If he gets a gigabit switch, his bandwidth problems will magically disappear without any intervention.
It caught you texting the other woman.
Thanks for the feedback guys. My network knowledge is extremely shallow to say the least but I imagine that solving my overloaded ethernet port by replacing my 100Mbit 16 port PoE+ switch with another one that has a 1 gigabit uplink would be far more expensive than offloading some of the cameras on to another smaller 100Mbit switch and then simply using another port in the 4P i350-t.
Your confusing me with the offloading. I don't fully understand your hardware configuration maybe draw it out. So I was re-reading your post on the previous page so your using three NICs, built-in nic for internet, and 2 of your additional 4 ports connected to two 16 port poe switches then your cameras? How many cameras are your talking about? Do you need 16 ports?
When you right click snapshots and do Analyze with DeepStack, do you still get nothing?
Then it’s probably your per-camera Trigger > AI settings. Can you post a picture of that AI window for this camera? Kind of hard to understand. So out of 20, you’re getting 15 successes and 5 not found?
Yes i have also tried this. And geting 15 out 20. At start was thought that was the pre trigger buffer that i had 7sec and thinking that the BI starting to count images for analyse at the moment that starting the pre trigger. I set the buffer to 2 sec but having same problem.
For this 2 cameras use as trigger from onvif of cameras with a door contact and pir conected to cameras.From the time that door open or trigger from pir take 5-6 sec to see person at the camera.So i play with the number of images for proccesing.Normal must have 6-7sec but i am try to find the problem with this #Alert cancelled (nothing found) # and playing with more images .
ok but I thought BI+Deepstack only worked with BI motion triggers and ignores ONVIF triggers. I am still fine tuning my BI triggers. Usually my CAMS see the motion first send onvif trigger but BI does nothing when BI see the motion then I see the deepastack check. Anyways I am wondering if your 5 misses are because they are onvif triggers and not bi.
