Ive owned this Foscam 19803P for a couple of months now and it just started to get buggy. Here are some pics.
This what it should look like. Then it will go haywire for a minute or two.
Like this.
Then it will go back to normal.
The cam is on WIFI. The router is within 35 ft. of the cam and my android wifi scanner reports high signal. I have tried four different routers. I've hard wired the cam and reloaded it into BI. then remounted it to run on wifi.
The only other changes are :
1. I tried out Windows 10 and went back to 7.
2. Tried out different routers.
3. Upgraded to a much faster Quad core CPU
My other three cams are in the same wireless range and are running fine.
The other concern is BI doesn't seem to run as well since I installed a new CPU. I think I read somewhere if you install a new CPU then a new uninstall/reinstall of BI is needed. ????
This what it should look like. Then it will go haywire for a minute or two.Like this.
Then it will go back to normal.
The cam is on WIFI. The router is within 35 ft. of the cam and my android wifi scanner reports high signal. I have tried four different routers. I've hard wired the cam and reloaded it into BI. then remounted it to run on wifi.
The only other changes are :
1. I tried out Windows 10 and went back to 7.
2. Tried out different routers.
3. Upgraded to a much faster Quad core CPU
My other three cams are in the same wireless range and are running fine.
The other concern is BI doesn't seem to run as well since I installed a new CPU. I think I read somewhere if you install a new CPU then a new uninstall/reinstall of BI is needed. ????
