DSC PC560 Alarm

[dastrix]

Hi All
Got given this and want to get it to work.

I can power it up, put a new battery on it and also its got a keypad and Crow PIR sensor

I tried the reset by bridging the PGM/Zone 1 wire. When it comes back up, all the zone lights are on and the system light won't go out.

*2 says its zone 3, tamper alarm? which is an issue but even before I had the PIR wired in, it still had the system light as yellow constantly.

The PIR has its tamper wires bridged, I powered it up off the alarm board and ran the 2 other wires into the Zone 1 and COM port

Is it dead?

Cheers

 

[wuhanspaceprogram]

*2 doesn't show tamper alarm on this panel. The only possible faults shown with *2 are shown here:



You may have your PIR wired incorrectly. Could you take a photo of the PIR wiring and post it?

 

[dastrix]

thanks for the reply! sure, ill get a photo during the week