DS2CD2132f-is keeps rebooting every few minutes

P

peku33

n3wb
Feb 16, 2015
8
0
Hi.

I have ip cam system with ~8 cameras. All are HikVision DS-2CD2x32.

Everything worked for some time (4 months), after that time one of cameras began to reboot.
It works for 10 minutes, gives image, etc, then reboots, 1 minute of boot, works for 5-10 minutes, reboots, etc.

I replaced this camera with new one and forgot about the problem, but after next few months it started to do the same.
This is the second camera failing in the same way.

It is connected to professional poe switch (port 13, heh), in the same way as all other cameras.

I did no firmware changes to cameras.

What can be the cause, how can i fix the camera?

Best regards,
peku33
 
Is it only on port 13 that it fails M sounds like it doesn't give good enough power on that port?

Sent from my One Plus X using tapatalk
 
No, of course I tried changing to others ports.

Could this be caused by oxidation / poor wire quality or is it rather camera hardware / software issue?
 
Ok. Did you plug it in indoors with just a short cable then just to check?

Sent from my One Plus X using tapatalk
 
Ok, i removed the camera, re-flashed the firmware.
Connected to +12V. Worked fine for 3 hours, after that i disconnected it and swtiched to PoE.
Right now I'm doing the PoE test. After 1,5h still no crash.

It might be something with wiring
 
You must log in or register to reply here.
Top Bottom