I have tested both intrusion rules and tripwire,rules whatever I attempt in settings and drawings the camera does not trigger any alarm.
(SMD is functioning ok and basic motion detection is also OK).
Testing: (Smart plans are not available in this camera) /2021-06-11 firmware release installed:
1. Daytime tripwire rule testing
2. A <> B straight line drawing
3. Period setting, 7 days a week 24 hours a day Green
4. Target filter efffective object tested with on and off
5, Target filter max 8191-8191, 0-0 and pixels 0-0 ( all defaults)
6. SMD enabled/disabled: no difference
Nothing happens based on the active rules, so Dahua tripwire does not work, and Dahua Intrusion also does not work in this model.
Who can help here? Could be user error, a firmware bug, or did someone at Dahua decide for commercial reasons to remove both tripwire
and intrusion capabilities from this model SMD camera...
Any help is appreciated!
Thanks
JK
(SMD is functioning ok and basic motion detection is also OK).
Testing: (Smart plans are not available in this camera) /2021-06-11 firmware release installed:
1. Daytime tripwire rule testing
2. A <> B straight line drawing
3. Period setting, 7 days a week 24 hours a day Green
4. Target filter efffective object tested with on and off
5, Target filter max 8191-8191, 0-0 and pixels 0-0 ( all defaults)
6. SMD enabled/disabled: no difference
Nothing happens based on the active rules, so Dahua tripwire does not work, and Dahua Intrusion also does not work in this model.
Who can help here? Could be user error, a firmware bug, or did someone at Dahua decide for commercial reasons to remove both tripwire
and intrusion capabilities from this model SMD camera...
Any help is appreciated!
Thanks
JK