Hi. Here Is what I found works best for the TiOC warm light.
Set a schedule for day and night. Go to the cameras web page and select
Camera > Conditions > Profile Management >
Schedule.
Drag the slider to set a suitable time for day and night time hours.
Hit the save button to apply the changes
In my example below day time is 5:20AM to 18:00PM
View attachment 183393
Go to
Camera > Conditions select the
Profile: Day
Go to
Illuminator and select
Fill Light: Warm Light Mode and
Mode: Off. (this will have the warm light off during scheduled day time hours)
Hit the Save button!
View attachment 183400
Change the Profile to
Night
Select
Fill Light: Warm Light Mode and
Mode: Manual. Set the brightness manually.
(this will have the warm light on during scheduled night time hours)
Hit the Save button!
You can also set it to Mode: Auto so the warm light gets brighter if it is too dark. You can also set Smart Illumination so the warm light will come on when it detects something.
View attachment 183401
By following the steps above you should have successfully setup a day and night schedule and the warm light should only come on at night.
If you are running one of the new Dahau 3X66 cameras the interface in the settings are in similar sub menus.
Camera > Image>Day/Night Switch. You then need to set the
Time Plan Settings
Setup the Day and Night profiles to how you want the Illuminator to function.
View attachment 183402
Set a Day and Night Time Plan so the camera knows which Illumination settings to use.
View attachment 183403
Please reach out if you need any further assistance.