Customized Day/Night settings not saving

[Defender574]

I've seen this talked about in a thread but couldn't hunt it down.

My two B54IR-ZE S3's were bouncing back and forth between modes at sunrise/sunset so I set a schedule for them under the customized scene tab in the GUI. I changed day to color and night to B/W and then placed the cams back on the Day/Night tab. I triple checked that there were no gaps in the time's but the cameras are not switching modes at the set times and still bouncing back and forth between modes.

Internet Explorer is being used, what am I doing wrong?

 

[bigredfish]

I dont use Day/Night for that and other reasons.

By switching back to Day/Night you're defeating the Schedule profile and allowing the camera to decide when to switch based on its light sensor.

I set my schedule times and leave it in Schedule profile as intended

 

[Defender574]

I dont use Day/Night for that and other reasons.

By switching back to Day/Night you're defeating the Schedule profile and allowing the camera to decide when to switch based on its light sensor.

I set my schedule times and leave it in Schedule profile as intended

So leave checked on the "Customized Scene" tab prior to exiting the GUI?

 

[bigredfish]

That’s what I do.
This allows me to set two completely different profiles (exposure etc) for day and night.

I have a few locations where I still leave Day/Night tab on Auto (still using the schedule profile however) to allow it to switch if I have a real dark area like my back porch where I have motion floods to kick it into color.