Cube (DS-2CD2432F-IW) How to Record Line Crossing events??

[GMD99]

I have a DS-7632N-E2/8P NVR (FW v.3.0.8, build 140825) and 4 cameras

- 2 x DS-2CD2032-I (FW - v.5.2.5)
- 1 x DS-2CD2132F-IS (FW - v.5.30)
- 1 x DS-2CD2432F-IW (FW - v.5.3.3)

I am trying to set up the Line Crossing alarm to cut down on the number of false alarms. However, when the Cube camera (the one I am testing) is connected to the NVR I am only hearing the audible alarm when the line crossing is triggered. There are no recordings and there are no logs!

On the camera:
- Enabled the Line Crossing detection and set the schedule for 24/7. On the Linkage I have ticked the Audible Alarm and the Trigger Channel and theTrigger Alarm Output ( I have no idea what these actually do!)
- I also enabled the Motion Detection with a schedule set for 24/7 and the same linkage setup as I did for the Line Crossing.

On the NVR:
- Schedule Settings, I set the schedule 24/7 for VCAMotion Detection
- Motion Detection, I enabled this and set Linkage Method to trigger channel
- VCA, enabled this and set Linkage Method to trigger channel

Any ideas on what I am doing wrong?

 

[normel]

I remember i had seen a clear manual on how to set it, but i coult not find it now.
What i can tell you, in the camera settings page, you have to enable the '' Enable Dual VCA '' option under advances video and audio settings. at display info on stream. So the ip camera communicates with your nvr