connect to vacation home (2 Tapo IP cameras) using Port Forwarding? (no VPN)

B

bgraff

n3wb
Mar 19, 2017
2
0
Hi all - i want to add 2 cheap Tapo IP cameras that i have at a vacation house to my primary BI network at my home. I use Eero hardware at both locations which do not support point to point VPNs. I was able to use Anycam to "see" 1 of the remote cameras using port forwarding.

My question is how to configure my BI system (at home) to access these 2 remote cameras using port forwarding?

i understand there are some security issues, but let's assume i am ok with the risk. My question is how to set it up in BI?

i tried using RTSP:/WWAN of remote site/stream1 and then i port forwarded 554 for the camera i wanted....

no dice.

thanks for any help!
 
If you're sure you want to do this, then include the forwarded port in the camera's URL to configure in BI such as rtsp:/RemoteSite-WAN-IP:554/stream1

NOTE: include 2 "/" after "rstp:" as forum software won't display 2 consecutively.

I would try the URL in VLC first before trying in BI.
 
Last edited:
  • Like
Reactions: bgraff
Tony - thanks for the reply! i was able to access the streams for all 3 cameras on VLC, but not able to replicate in BI. i will keep trying things... but any ideas?
 
bgraff said:
Tony - thanks for the reply! i was able to access the streams for all 3 cameras on VLC, but not able to replicate in BI. i will keep trying things... but any ideas?
Click to expand...
Post a screenshot of 1 of the Tapo's configuration in Blue Iris.
No IP's need be redacted except for the WAN IP of the remote site.
 
Try this:

Remote-Tapo-RTSP_1.jpg
 
bgraff said:
Hi all - i want to add 2 cheap Tapo IP cameras that i have at a vacation house to my primary BI network at my home. I use Eero hardware at both locations which do not support point to point VPNs. I was able to use Anycam to "see" 1 of the remote cameras using port forwarding.

My question is how to configure my BI system (at home) to access these 2 remote cameras using port forwarding?

i understand there are some security issues, but let's assume i am ok with the risk. My question is how to set it up in BI?

i tried using RTSP:/WWAN of remote site/stream1 and then i port forwarded 554 for the camera i wanted....

no dice.

thanks for any help!
Click to expand...

If you insist on port forwarding at least limit the ip addresses that can access the port ..
 
A much better option would be to install tail scale on your BI computer then add a low power computer (raspi) at your vacation home also with tail scale installed. Then the low power computer can advertise the 2 cameras directly to BI computer but securely
 
  • Like
Reactions: mat200
You must log in or register to reply here.
Top Bottom