configuring dahua hfw 5231e-ze

G

gregdz

n3wb
Aug 31, 2018
21
7
heyworth
I used the dahua config program to set up my new dahua camera. The camera is
connected as a poe camera with a 12v injector. When I do the initial
search with the program I get 192.168.0.239. This is correct since I can
view the connections on my router.

Next I try a web log in and get the message "cant reach this page".

Next I try to modify the ip to 192.168.0.108 . The ip does not change
and a triangle with a red mark appears by the ip.

What is wrong? How do I get a proper configuration so I can log in using
the web browser?

Thanks,

Greg
 
The default ip address should be 192.168.1.108, set, on your laptop, a static ip address like 192.168.1.100/24, connect the camera at 192.168.1.108, and set it to DHCP, or set an ip address consistent with your current network.
Cheers,
 
On your laptop ? 192.168.1.108 should be the cam, you should use eg. 192.168.1.110
 
Yes, you can... setup up TCP/IP V4 as in the picture.

Direct connect the Dahua to your PC.

Reboot.

Then in any browser type 192.168.1.108.

Set PW and after change IP to your network.

upload_2019-1-4_21-14-24.png
 
  • Like
Reactions: bigredfish
Does it work.... feedback???
 
@gregdz...temporarily add a static 192.168.1.x to your ethernet adapter and you will be able to log into your Dahua camera @ 192.168.1.108...

ip.jpg
 
  • Like
Reactions: Arjun and ljw2k
The camera works fine. Your suggestions were great which I then used to show the new camera was working. I then changed the lan ip address from 192.168.0.1 to 192.168.1.1 on my asus router. Thanks everyone.
 
  • Like
Reactions: Q™
bump, this thread should be stickied, almost everyone experiences this even after a camera is reset to factory default ;)
 
I use dot1x, with auth failed vlan XX, this VLAN XX is the192.168.1.0/24 network, so, I can reset one camera at time, and reconfigure without too much troubles, if needed.
Cheers,
 
You must log in or register to reply here.
Top Bottom